Attaching Peripherals - Siemens RM400 C Series Operating Manual

5.1

Attaching peripherals

Once you have installed your system unit and your monitor, you can start attaching
the peripherals.
To tighten the securing screws on the cable connectors you will need a small
flathead screwdriver and a small crosspoint screwdriver.
When you are making the connections between the system unit and the
!
peripherals, the system unit must be off and devices must not be plugged
into the power.
The system unit, the monitor and the peripherals must all have the correct
line voltage.
All cables and lines must be routed in such a way that no-one can tread
on them or trip over them.
You must use shielded connecting cables to attach your peripherals to the
system unit.
The system unit and the peripherals must all be connected to the same
distribution board to prevent the flow of compensating currents.
If this is not possible, a transmission method for differing distribution
boards must be used, even for short distances.
If the above connection conditions are not fulfilled, data transmission malfunctions
and damage to the equipment may result.
U24802-J-Z146-2-7600 RM400 C Models
Installing peripherals
5
39