Notes On Safety - Siemens RM400 C Series Operating Manual

2.1

Notes on safety

This device complies with the relevant safety standards for IT equipment, including
electronic office machines, intended for use in the office environment.
Observe the safety instructions in the manual "RM Systems - Safety
!
Instructions", which is supplied with your system.
This section contains important notes on safety which you must observe
when using your system.
If you have any questions relating to setting up and operating your system in the
environment where you intend to use it, please consult our service department.
Transport the device in its original packaging or in other suitable packaging
which will protect it against shock or impact.
Read the notes on environmental conditions in the chapter "Technical data" on
page 145 before setting up and operating the device.
If the device is brought in from a cold environment, condensation may form
both inside and on the outside of the machine.
Wait until the device has acclimatized to room temperature and is absolutely
dry before starting it up.
Check that the rated voltage specified on the devices ID plate is the same as
the local line voltage.
The device is fitted with a tested and approved power cable and must only be
connected to properly grounded socket outlets.
Make sure that the wall outlet of the building's wiring system is freely acces-
sible.
Switching off the device does not cut off the supply of power. To do this you
must remove the power plugs (to counteract the risk of lightning strikes).
If your system has a battery backup unit (BBU), it will continue operating even
if you pull out the power plugs.
In emergencies you can switch off devices which have a BBU, by turning the
keylock switch to LOCAL and pressing the [ON/OFF] switch. But this may result
in the loss of data.
U24802-J-Z146-2-7600 RM400 C Models
2
Important notes
9