Siemens RM400 C Series Operating Manual page 183

Addresses for SCSI devices in peripherals cabinets
Peripherals cabinets are attached to SCSI controllers installed in the optional slots
in the system unit. Both EISA and PCI controllers can be used. The addresses of
hard disks in peripherals cabinets can be listed with the autoconf command.
Configuration of peripherals cabinets is handled by the SNI service personnel.
Addresses for the floppy disk drive
The floppy disk drive in the system unit has its own controller.
Major/minor Capacity
dev. number
23/116 1440 Kbyte
1
Other additional device names have been set up for some device entries.
U24802-J-Z146-2-7600
Device names in Reliant UNIX/
SINIX V5.42
/dev/at/flp/[r]fx3h
RM400 C Models
Equipment settings
1
14
173