Drum Crum C Not In Position - Xerox Phaser 7500 Service Manual

Error Messages and Codes

Drum CRUM C Not In Position

Applicable Chain-Link Code
Initial Actions
3-262
The Drum C CRUM is not in the proper position. (Loose CRUM)
• 091-929: Drum CRUM C Not In Position
• Power cycle the printer.
• If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Drum CRUM Coupler Assy (C),
■
PL8.1.3
Imaging Unit, PL8.1.4
■
MCU PWB, PL18.3.6
■
Motor Drive PWB, PL18.3.7
■
1. Remove and reinstall the Imaging Unit (C) (REP 1.2,
2. Polish the connection terminals between the Drum (M) CRUM PWB and the
Drum CRUM Coupler Assembly (C) CRUM with dry cloth. (When cleaning, do
not use drum cleaner, etc.)
3. Check the following:
• The connection between the Motor Drive PWB J526 and the Drum CRUM
Coupler Assembly (C) P114 for open circuit, short circuit, and poor contact.
• The connection terminals between the Drum (C) CRUM PWB and the
Drum CRUM Coupler Assembly (C) CRUM for damage and debris.
• The Imaging Unit (C) for improper installation.
4. If no problems are found, replace the following parts in sequence:
• Imaging Unit (C) (REP 1.2,
• Drum CRUM Coupler Assembly (C) (PL8.1.3)
• Motor Drive PWB (REP 18.13,
• MCU PWB (REP 18.12,
Wiring and Plug/Jack Map References
page
page 8-10)
page 8-204)
page 8-202)
Phaser 7500 Printer Service Manual
8-10).