Rep 5.8 Developer Beads - Xerox Phaser 7500 Service Manual

Hide thumbs Also See for Phaser 7500:

Table of Contents

Service Parts Disassembly

REP 5.8 Developer Beads

When removing the Developer Housing Assembly, be careful not to

contaminate the Developer Housing Assembly.

1. Remove the Developer Housing Assembly (REP 5.5,

2. Release the Front and Rear Latches of the Developer Cover.

3. Remove the Upper Cover.

4. Installing the Developer Beads into the Developer.

Place the Developer Assembly on a drop cloth or a few sheets of paper to

catch any spills.

Agitate the package of the developer mix and then cut it open.

While keeping the Developer Housing Assembly level, carefully pour the

entire contents of the developer mix package as evenly as possible over

the two augers. Do Not let the developer mix accumulate heavily on the

magnetic roller.

Re-install the Upper Cover by inserting the four tabs on the Cover into the

corresponding slots of the Developer Housing and then press directly on

the latches until each latches in place. Press firmly until you hear a

positive 'snap' sound for each tab indicating the tab is latched.

5. Tear off the loose half of the ATC Sensor perforated tag. Leave the other half

of the ATC Sensor Label on the Developer Housing. Peel off the protective

backing and adhere the label to the Plate (PL8.1.7), above the corresponding

6. Install the Developer and perform the ATC Sensor Setup in Diagnostics. Enter

the value from the tag removed from the replacement Developer. Follow the

"ATC Sensor Setup" on page 6-5

(Calibrations in Chapter 6).

Phaser 7500 Printer Service Manual