Heat Roll Paper Winding Fail - Xerox Phaser 7500 Service Manual

Heat Roll Paper Winding Fail

Phaser 7500 Printer Service Manual
From the monitor value of the Rear Control Thermistor and Center Control
Temperature Sensor, it was detected that paper is wound around the Heat Roll.
Note
To clear this error, perform Clear Tech Rep Faults in Diagnostics and then turn
the power Off and On.
Applicable Chain-Link Code
• 010-337: Heat Roll Paper Winding Fail
Initial Actions
• Power cycle the printer.
• If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Fuser Assy, PL7.1.1
■
1. Remove the jammed paper.
2. Perform Clear Tech Rep Faults in Diagnostics then turn the power Off and On.
3. Is paper used out of specification (refer to
page 1-19).
4. If no problems are found, replace the Fuser Assembly (REP 7.1,
Error Messages and Codes
Wiring and Plug/Jack Map References
"Paper and Tray Specifications" on
page 8-67).
3-75