Service Diagnostics Menu Map - Xerox Phaser 7500 Service Manual

Reference

Service Diagnostics Menu Map

Print Service Menu Map Print Service Menu Map
P Prints this service diagnostic menu
m map after exiting service diagnostics.
G General Status
Provides the current print engine temperature
s status.
Ambient Temp/Humidity
Fuser Temperature
B Built-in Test Prints
Prints Test Prints. Use the prints to identify,
repair, and validate printer operation. r
Dummy Cycle
Test Print Setup
90 Degree Grid
B Patch
Drum Pitch Halftone
Sensor/Switch Tests S
Tests the functionality of the sensors and
switches by actuating and stating changes of all sensors and s
switches. s
Ambient Temp/Humidity
Interlocks
Switches
Jam Sensors
OHP Sensor
Tray Feed Sensors
Accum MOB Sensor
BTR Retract Sensors
IBT Belt Home Sensor
ADC Sensor
Auger Lock Sensor
Toner Waste Cartridge Sensors
Tray 1 (MPT) Sensors
Tray 2 Sensors
Tray 3 Sensors
Tray 4 Sensors
Tray 5 Sensors
ATC Sensors
NOHAD ENV Sensor
Fuser NC Center Sensor
Fuser STS Rear Sensor
11-4
h d
M Motors/Fans Tests /F T
Tests the functionality of the motors and T h fl
fans by energizing/de-energizing one at a time.
Main Motor
IBT Belt Motor
BTR 1/2 Contact & Retract
Duplex Motor
Registration Roller
Paper Feed Motors
Paper Lift Motors
Developer Motors
Dispenser Motors
Agitator Motor
Fuser Drive Motor
Tray Module TakeAway Motor
Exit Motor
Fan Motors
Clutch Tests
Tests the functionality of the clutches by
energizing/de-energizing one clutch at a time.
First BTR Retract Clutch
Registration Clutch
Solenoid Tests
Tests the functionality of the solenoids by
energizing/de-energizing one solenoid at a time.
ADC Shutter Open
ADC Shutter Close
Adjustments/Calibrations
Performs adjustments, calibrations,
and operations essential to the performance of the printer.
ATC Sensor Setup
ADC Output Check
RegiCon Check
RegiCon Calibration
LED EEPROM Check
Maintenance
Cleans the Fuser Roller with blank prints.
Clean Fuser
NVRAM Access
Reads, sets, or resets the following values:
PostScript NVRAM Reset
Clear Tech Rep Faults
Reset CRU Life Counters
Clear Y Developer Page Count
Clear M Developer Page Count
Clear C Developer Page Count
Clear K Developer Page Count
Restore Engine NVRAM
Store Engine NVRAM
NVRAM Read/Write
Exit
Exits service diagnostics and reboots the printer.
For Authorized Service Personnel Use Only.
functions are to be used by Xerox service personnel and au-
thorized service providers only. The printer can be damaged by
improper use of the built-in service tests.
Phaser 7500 Printer Service Manual
f h d
Service Menu
s7500-449