Rep 3.8 Drum/ Deve Drive Assembly - Xerox Phaser 7500 Service Manual

REP 3.8 Drum/ Deve Drive Assembly

PL3.3.1
Phaser 7500 Printer Service Manual
1. Remove the PWB Chassis Unit (REP 18.10,
2. Remove the HVPS (1st/ 2nd/ DTS) (REP 6.4,
3. Disconnect the 4 wiring harness connectors on the Drum/ Deve Drive
Assembly that are connected to the Harness Holder, which is installed on the
right (when seen from the rear), and release the hook to remove the Harness
Holder.
4. Disconnect the 4 wiring harness connectors on the Drum/ Deve Drive
Assembly that are connected to the Harness Holder, which is installed on the
right (when seen from the front), release the harness from the Retract Drive
Assembly Harness Guide, and release the hook to remove the Harness Holder.
5. Remove 2 screws that secure the Bottom Fan Assembly (PL4.3.6)
6. Disconnect the wiring harness connector and remove the Fan.
page 8-197).
page 8-65).
Rear Bottom Duct Assembly
Service Parts Disassembly
s7500-482
8-33