Error Messages and Codes
Drum CRUM Y Communication Fail
Applicable Chain-Link Code
Initial Actions
3-256
Communication failure with Drum (Y) was detected.
•
091-917: Drum CRUM Y Communication Fail
•
Power cycle the printer.
•
If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Drum CRUM Coupler Assy (Y),
■
PL8.1.3
Imaging Unit, PL8.1.4
■
MCU PWB, PL18.3.6
■
Motor Drive PWB, PL18.3.7
■
1. Turn the power Off and On.
2. Check the following:
•
The connection between the Motor Drive PWB J526 and the Drum CRUM
Coupler Assembly (Y) P112 for open circuit, short circuit, and poor contact.
•
The connection terminals between the Drum (Y) CRUM PWB and the
Drum CRUM Coupler Assembly (Y) CRUM for damage and debris.
•
The Drum (Y) CRUM PWB for contamination or disengagement.
•
The Imaging Unit (Y) for improper installation.
3. If no problems are found, replace the following parts in sequence:
•
Imaging Unit (Y) (REP 1.2,
•
Drum CRUM Coupler Assembly (Y) (PL8.1.3)
•
Motor Drive PWB (REP 18.13,
•
MCU PWB (REP 18.12,
Wiring and Plug/Jack Map References
page
8-10)
page
8-204)
page
8-202)
Phaser 7500 Printer Service Manual