Error Messages and Codes
3-154
Troubleshooting Procedure (Continued)
Step
Actions and Questions
2
Check the following:
The Flat Cable between the MCU
■
PWB J556 and the LPH Rear PWB
(M) J560 for open circuit, short
circuit, and poor contact.
The Flat Cable between the LPH H
■
PWB (M) J568 and the LPH (M)
J576 for open circuit, short circuit,
and poor contact (connection
within the LPH Unit).
The connector (P/J580) between
■
the LPH Rear PWB (M) and the
LPH H PWB (M) for damage and
debris.
The LPH Unit (M) for improper
■
installation.
Perform the LED EEPROM test in
■
Diagnostics.
Are they normal, without any short
circuits, poor contacts, and etc.?
Yes
No
Replace the
Repair the
following parts
sections that
in sequence:
have short
circuits and
LPH Unit (M)
■
(REP 2.1,
poor contacts.
page
8-18)
LPH Cable
■
Assembly
LPH Rear
■
PWB (REP
2.4,
page
8-22)
MCU PWB
■
(REP 18.12,
page
8-202)
Phaser 7500 Printer Service Manual