Error Messages and Codes
Tray 4 Paper Size Sensor Broken
Applicable Chain-Link Code
Initial Actions
3-204
Abnormal output AD value from Tray 4 Size Sensor was detected.
•
073-212: Tray 4 Sensor Fail
•
Power cycle the printer.
•
If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Tray Module PWB, PL10.9.1
■
MCU PWB, PL18.3.6
■
Motor Drive PWB, PL18.3.7
■
TM Relay PWB, PL18.3.11
■
1. Perform the following steps:
•
Check the bottom of the Tray for broken link and damage.
•
Check the Actuator at the rear of the Tray for operation failure.
•
Perform the Tray 4 Sensors test in Diagnostics.
•
Check the connection between the Tray 4 Paper Size Sensor J102 and the
Tray Module PWB J549 for open circuit, short circuit, and poor contact.
2. If no problems are found, replace the following parts in sequence:
•
Tray Module PWB (REP 10.9,
•
TM Relay PWB (REP 18.14,
•
Motor Drive PWB (REP 18.10,
•
MCU PWB (REP 18.12,
Wiring and Plug/Jack Map References
page
8-97)
page
8-205)
page
8-197)
page
8-202)
Phaser 7500 Printer Service Manual