Tray 5 Lift Up Fail - Xerox Phaser 7500 Service Manual

Tray 5 Lift Up Fail

Phaser 7500 Printer Service Manual
Tray 5 Lift Up error has occurred.
Applicable Chain-Link Codes
• 074-210: #5 Lift Up Fail 3 Times in a Row
• 074-940: #5 Lift Up Fail
Initial Actions
• Power cycle the printer.
• If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Tray 3/4/5 Feed/Lift Up Motor,
■
PL10.3.3
Tray Module PWB, PL10.9.1
■
MCU PWB, PL18.3.6
■
Motor Drive PWB, PL18.3.7
■
TM Relay PWB, PL18.3.11
■
Troubleshooting Procedure
Step Actions and Questions
1
Remove Tray 5.
Perform the Paper Feed Motors
test in Diagnostics.
Does the Tray 5 Feed/ Lift Up
Motor rotate?
2 Is the voltage between the Tray
Module PWB J541-10 (+) and the
GND (-) +24VDC?
Error Messages and Codes
Wiring and Plug/Jack Map References
Yes
Go to step 5.
Go to step 3.
No
Go to step 2.
Go to "+24 VDC
Power" on
page 4-16 for
troubleshooting
procedure.
3-205