Service Diagnostic Tests And Utilities - Xerox Phaser 7500 Service Manual

Service Diagnostic Tests and Utilities

Service Diagnostics Tests and Utilities
Test
Print Service Menu Map - Prints the Service Diagnostics menu then exits diagnostic mode.
General Status - Provides the following print engine status:
Ambient
Temperature/
Humidity
Fuser Temperature
Built-in Test Prints - Prints test prints stored in the Engine Control Board.
Dummy Cycle
Phaser 7500 Printer Service Manual
Warning
While in diagnostics mode, the printer will not power Off using the Power
Switch. To properly power Off the printer, exit diagnostics, and after reboot,
set the Power Switch to the Off position.
Control Panel Display and Test Definition
Ambient Temperature: ##
Ambient Humidity: ## %
Fuser Temp is: <value>
Dummy Cycle
Displays the current Temperature
o
C
and Humidity for the printer.
Displays the current Fuser
temperature.
Select this after printing a test print
and before selecting a different
test print to print. Also, select this
after printing a test print and
before running a component test.
The process is to print whatever
test print is desired, allow the IOT
to cycle down, run the dummy
cycle, allow the IOT to cycle down,
then select another test print or
component test
Reference
11-5