Toshiba STRATA DK24 Manual page 669

STEP
1
2
6
7
8
REMOTEADMIN &MAlNTPROCEDURES
SECTlON200-096-600
FEBRUARY1991
TABLERM-BG
MODE96
REMOTECALLEDSTATION MESSAGlNG(ADD/CHANGE)
ACTION
Enter the Message Mode
At the >MODE prompt, enter fl 0 a H
q
.
To Change or Add a New Called Station Message
Set the terminal keyboard to the lower case (cap lock off) and
enter Q[I
NOTE:
Enter "m" (lower case) anytime it is desired to start over
in this procedure.
Enter 1 1 13 (XXX = destination station number or destination
station group number - 30 = all EKTs, 31 - 34 per system,
Program 31).
Enter ![[I (p = page command and YYY = originating
station number).
Enter B 00 (p = page command and
00 = 2-digit message memory location: 10 * 19 personal
messages and 60 w 99 = system messages).
To Add the New Message [M]
Set the terminal keyboard to upper case and enter message
as required (alphanumeric, 32 characters max.). New message
displays as it is entered.
To Set the Message
Set the terminal keyboard to lower case and enter B 11
.
Destination station: MW/FL LED flashes, "CALL YYYM" is
displayed on LCD.
Origination station: "SENT XXXM" is displayed on LCD.
To Exit the Message Mode
At any time, enter m 11 (lower case).
DISPLAY/PRINTOUT
>MODE MESG
m 96
m96 XXX
m96 XXX p YYY
m96 XXX p YYY pflo
m96 XXX p YYY pnn[M]
m96 XXX p YYY pnn[M] p
m0
-L
Zero
m0
q
>MODE
NOTES:
1. [M] represents the message entered.
2. With
Release
2 software only, remote called station messaging is not available from electronic
telephones, but it is available from ASCII terminals connected to the TTYport or via IMDU on the
PIOU or PIOUS.
-55-