Toshiba STRATA DK24 Manual page 547

FEATURE USE
FEATURE USE
DIRECT STATION SELECTION BUTTONS (HOTLINE)
PROGRAMMABLE OPTION (continued)
busy) of that station. If connected to a CO line, pressing this
button will put the party on hold. Transfer the call as you would
normally, by voice announcing or camping on by hanging up.
DOOR LOCK
Pressing the m button momentarily activates a switch con-
nected to a door lock or similar device.
Door Lock Button
DRLK 0
DRLK 1
DRLK 2
DRLK 3
DRLK 4
Location
MESSAGE WAITING
If someone calls your telephone and you are unable to answer,
the calling party may set the Message Waiting indicator (a
flashing red LED) on your telephone.
The Message Waiting indicator is the MESSAGE LED.
Up to four Message Waiting indications may be queued on the
message indicator at one time. One of the four message indica-
tions is always reserved for the Message Center; the other three
may be set from any other telephone or voice mail device.
TO ANSWER A MESSAGE WAITING INDICATION ON YOUR
TELEPHONE
1) If the MESSAGE LED is flash elephone: Lift the
handset, press the m and buttons, respec-
tively.
l
This calls the station that set the message indicator.
l
Wait for an answer to receive the message.
MESSAGE WAITING (continued)
NOTE:
If there is no answer, hang up and try at a later time (the
MESSAGE LED continues to flash).
2) After receiving the message, place the handset on hook.
If the MESSAGE LED turns off, you have no more
messages.
If the MESSAGE LED continues to flash, you have
more messages-repeat steps 1 and 2 to retrieve
them.
If the flashing message LED was turned on by a voice
mail device, the device will cancel the indication after
a short delay. The cancel time depends on the voice
mail device's parameters.
NOTE:
telephone does not have a B button, dial
TOSETTHEMESSAGEWAlTlNGINDICATORONANOTHER
TELEPHONE
1) At your telephone: Lift the handset, press them button and
dial the desired intercom number.
2) If the called telephone does not answer: Press the
B button to set the message indication (or dial@.
l
The MESSAGE LED flashes at the called telephone.
l
The MESSAGE LED illuminates steady at your tele-
phone.
3) Place the handset on-hook.
l
The MESSAGE LED flashes at the called telephone.
l
The MESSAGE LED turns off at your station.
l
The MESSAGE LED continues to flash at the called
telephone.
TO CANCEL THE MESSAGE WAITING INDICATION SET
FROM YOUR TELEPHONE
Lift the handset, dial the intercom number of the telephone that
44