Toshiba STRATA DK24 Manual page 371

PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECOROS
SECTION 200-096-302
FEBRUARY1991
PROGRAM30
STATION CLASSOFSERVICE
(PORTS 00 -31)
SELECT = Port Number(s) 1
I Key LEDs
Enter the port number(s) to which class
Light LEDs for the port specified in the
of service must be assigned. See Note 4
last step. All Key.s/LEDs marked with
for entering a range of ports.
an "X" in the table below should be lit.
Feature
Key
Port Numbers 00-31
LED 00101 ~02~03~04/05~06/07~08~09~10~11~12~13~14~15~16~17~18/19~20~21~22~23~24/25/26~27
/
I I I III III I III I
III I I
Change Verified A.C. (R3)"
Account Codes Verified (R3)
Digital Tele. Recv. Vol. (R3)14
Digital Tele. Recv. Vol. (R3)14
Chanae DISA Securitv Code8 IR21
" 3 I I .-
Change TR Override Code 12 09
Forced Acc't Code
08 /Jo 1 1 '
OCNBusy Override Automatic5
07
I I I I I I I I
ABR Access Enabled
Speed Dial Allowed
I I I
MIC on at Start of Call 13
l03liilI1
I / I I j iii i i Ii i iii i iii I I
MIC Key Lock Enabled I3 1 02 11 i j 1 j 1 j 1 j i I i j
i i I
Speakerphone Enabled
1011 I I / II
i / I I I
28 29 30 3
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data reads LEDs 01, 05, 07, and 12 ON for all ports.
3.
Ports 32 - 95 on next page. The same notes apply to all ports.
4. A range of ports may be specified by entering
_
q [7'El00
Low port in range i -High port in range
5. If this LED is turned OFF, OCA and Busy Override must be accessed manually by dialing1 If kept ON, ACB and Executive Override
cannot be accessed.
6. If all stations are allowed Privacy Override, (the system will be non-private), allowing up to three telephones to talk on the same CO line.
7. See Program 10-2 to enable/disable Priv./Exec./DND override warnina tones.
8. Change DISA security code is available with Release 2 and above softw>re only. To change DISA code from selected stations: Dial
mBII+code+i.
9. DP or DTMF is specified for standard telephones only, PSTU or PEW (circuits 1 and 2).
IO. To change a 4-digit Traveling Class Override (T. C. 0.) code: Dial m +
q
0
q
+ code + 1.
lxln =lil-Cl
assl,~II-Class2,~~0-Class3,~~~-Class4.
Il. To change verified account codes from selected stations: Dialm + III+ Code Number (000 - 299) + code
(I - 15 digits) + 1, Note that the total account code digit length is set in Program 60-4; all digits do not have to be verified.
12. To change the 4-digit T. R. override codes (1 or 2) from selected stations: Dialm + 111 + coae + 3 arm + 1 B 8+ code + I.
13. MIC ON/OFF at start of call (LED 03 ON = MIC ON, LED 03 OFF = MIC OFF) is only in effect if MIC key lock is enabled (LED 02 = ON).
14. There are nine handset receiver volume levels, 1 * 9 (9 being the highest). The initial off-hook /eve/ can be set anywhere from level 2 to 5. Set the initial
level with one of the following combinations: Level 2 = 12 OFF/13 OFF; Level 3 = 12 ON/l3 OFF [default level); Level 4 = 12 OFF/13 ON;
Level 5 = 12 ON/13 ON.
2-71