Toshiba STRATA DK24 Manual page 332

PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS
SECTION 200-096-302
FEBRUARY1991
ing CO line access to stations, including
LCR access.
l
Program 41
allows CO line access to sta-
tions using LCR only for outgoing calls
when enabled.
2: Modified Digits Table (1
W 6): Refer to
Pro-
grams
55-0, 55-l and 55-2. The system
handles CO line groups differently, according
to which modified digits table was assigned in
Program 54.
7.40 Program 55 Series-LCR Modified Digits
Tables
7.41
This program defines six modified digits tables
for LCR call handling. Each modified digits table
assigns editing steps that include:
l
Deleting a pre-defined quantity of digits from
the front of the number dialed
(Program 55-O).
l
Adding a pre-defined number to the front of the
number dialed
(Program 55-l).
l
Adding a pre-defined number to the end of the
number dialed
(Program 55-2).
7.42 The purpose of this program is to define call
handling so the route definition used by LCR is
invisible to the station user. The station user handles
all calls the same way. The goal is for LCR to
remember the dialing peculiarities of each call
route, so the user doesn't need to know.
7.43 Program 55-O-LCR Modified Digits-De-
lete:
Enter the
Quantity of Digits
that should be
deleted from the front of the numberdialedfor each
of the six
Table Numbers
in the
Delete Digits
Table.
The maximum number is ten. Always make
the entry two digits.
7.44 Program 55-l -LCR Modified Digits-Add
to Front of Dialed Number:
Enter the digits that
must be added to the front of the number dialed in
the
Add Digits Table.
The maximum quantity of
digits is 22, including pauses.
l
Length of pause can be indicated by using
codes (Pl N P8) specified in the
Pause Entry
ReferenceTable.
Each pause takes ttio digits
of memory space.
l
Try to allow for the longest wait, e.g., make the
pause longer, rather than shorter, to accom-
modate the length of time a carrier may need to
access the service tones, etc.
7.45 Program 55-2-LCR Modified Digits-Add
to End of Dialed Number:
Enter the digits that
must be added to the end of the number dialed in
the
Add Digits Table.
The maximum quantity of
digits is 22, including pauses.
l
Length of pause can be indicated by using
codes (PI N P8) specified in the
Pause Entry
Reference Table.
Each pause takes two digits
of memory space.
l
Try to allow for the longest wait, e.g., make the
pause longer, rather than shorter, to accom-
modate the length of time a carrier may need to
access the service tones, etc.
7.46 Program 56-LCR Station Group Assign-
ment:
The purpose of this program is to assign all
defined station ports to one of four LCR Station
Groups.
l
Station groups are completely independent of
one another. Therefore, each station group
must be defined separately.
l
Software does not automatically assign the
highest, all-inclusive routing priority to class 1
stations, making all routes available to class 2,
3 and 4 stations available to class 1 as well.
l
Instead, stations are assigned to independent
groups (partitioned). Completely flexible as-
signment of routing definitions to groups is
allowed, with no one group's definition affect-
ing another's, Each group's route definitions
are specified to activate separately according
to the time schedules set by
Program 53.
1:
Enter the station group number next to the port
number.
2-32