Toshiba STRATA DK24 Manual page 532

FEATURE USE
AUTO BUSY REDIAL (continued)
TO CANCEL ABR
Press the m button (or m 1 I).
NOTES:
1. ABR will not be attempted while the station is busy on
another call but will continue to time-out.
2. With each attempt:
The CO (or IiT) and SPEAKER LEDs blink when the
line is seized.
Dial tone is heard via the speaker.
Telephone number is redialed.
If busy, ABR will reset and try again.
If a connection is made, ring tone sounds until called
party answers.
If the originatin station does not pick up the handset
(or press the h
button) after a connection is
made (it will ring back three times), ACB mute ring
sounds for 30 seconds and then the call disconnects.
SPEED DIAL
TO CALL A SPEED DIAL NUMBER
1) Lift the handset.
2) Press any available
q
line button.
l
Listen for dial tone.
3) Press the m (or the [) button (see Note).
4) Dial the 2-digit speed dial code for the desired telephone
number.
l
'Your system will automatically dial the number for you.
5) Hang up when the call is completed.
TO CHAIN DIAL AUTOMATICALLY
Dials two or more speed dial numbers during one call.
1) Lift the handset.
2) Press any available
q
line button.
l
Listen for dial tone.
SPEED DIAL (continued)
3) Press them (or the 1) button (see Note).
4) Dial the 2-digit speed dial code for the first telephone
number to be dialed.
5) Press them (or the 1) button.
6) Dial the 2-digit speed dial code for the second telephone
number to be dialed.
7) Repeat the above steps for each subsequent number to be
dialed.
l
Yoursystem will automatically dial the number for you.
8) Hang up when the call is completed.
NOTE:
lfyour telephone does not have an= button, the 1 button
serves the same function.
SPEED DIAL BUTTONS
PROGRAMMABLE OPTION
After accessing a CO line, speed dial is available by pressing an
q
button instead of a 2-digit access code. Eachm button stores
one telephone number (up to 20 digits).'
TO STORE A TELEPHONE NUMBER*
1) Do not lift the handset.
2) Press the 1 (or m) and fl (or m) buttons, respec-
tively.
3) Press the
q
button you wish to use.
4) Dial the telephone number to be stored (20 digits maxi-
mum).3
5) Press the 1 (or m) button to record the number in
memory.
6) Repeat the above steps for each
q
button.
NOTES:
1. Up to 37 digits by linking two speed dial numbers (see
the link procedure that follows).
14
15
./'