Toshiba STRATA DK24 Manual page 668

REMOTE AOMIN & MAINT PROCEDURES
SECTION 200-096-600
FEBRUARY 1991
TABLE RM-BF
MODE 94
REMOTE CALLED STATION MESSAGING (ADD/REVIEW/CHANGE) .
iTEP ACTION
DISPLAY/PRINTOUT
1
Enter the Message Mode
>MODE MFSG
At the >MODE prompt, enter m 0 1 H [9 .
2
To Add Or Review a Called Station Message m
94
Set the terminal keyboard to the lower case (cap lock off) and
enter min.
3 Enter 0 1 0(XxX = Destination station number or destination m94 xxx
group number [30 = all stations, 31-34 per system, Program 311).
4 Enter 11 m 1 (p = page command [lower case] and
1 u 13 = originating station number).
m94 XXX p YYY
5 Enter Ino (p = page command [lower case] and
00 = 2-digit message memory location: 10 - 19 personal
m94 XXX p YYY pun [M]
messages and 60 u 99 = system messages).
After b 00 is entered, the previously stored message (M) is
displayed. (If there is no stored message, nothing is displayed.)
6
To Change the Message (M+)
m94 Xxx p YYY pun [M+]
Set the terminal keyboard to upper case and change message
as required (alphanumeric, 32 characters max. for total message).
7
To Set Message
Set the terminal keyboard to lower case and enter B 11 .
m94 XXX p YYY pun [M+] p
m0
Destination station: MW/FL LED flashes, "CALL YYYM" is
displayed.
-L
Zero
Origination station: "SENT XXXM" is displayed.
8
To Exit the Message Mode
m0
At any time, enter1 11 (lower case).
q
>MODE
NOTES:
1. Press 1 at any time to start over.
2. [M] represents the message entered.
3. With
Release
2 software on/y, remote called station messaging is not available from electronic
telephones, but it is available from ASCII terminals connected to the
TTYport or via III/ID(J on the
PIOU or PIOUS.
-54-