Toshiba STRATA DK24 Manual page 627

REMOTEADMlN&MAlNTPROCEDURES
SECTlON200-096-600
FEBRUARY1991
TABLERM-K
PROGRAM03
FLEXIBLEPCBSLOTASSIGNMENTS
;TEP
ACTION
DISPLAY/PRINTOUT
1
Enter the Program Mode
>MODE PROG
At the >MODE prompt, enter w 1 m 1 (9. P
2
Enter Program Number 03
P 03
Press
q
. PO3
3
Enter the Slot Number
PO3
Refer to the System Record Sheet and enter the desired
PO3 00 91
slot number.
Example: Slot number 00, enter 1 1.
4 Enter the PCB Code Number
PO3
Refer to the System Record Sheet and enter the desired
PO3 00 91 92
PCB code number.
Example: PCB code 92, enter 1 1 .
5
To Exit Program/Store Data
PO3
A) To store data, press
q
. PO3 00 91 92
B) Continue returning to step 3 until all Program 03
PO3 ##
data is entered. P
C) To exit this program, press 1 1, press
q
6
Turn system power "OFF" for 5 seconds and then turn
Remote maintenance is disconnected.
power "ON" to store data in working memory (see Notes).
IMPORTANT NOTES:
1. This program must be completed with on-site assistance (after installing PCBs) because the
system must be powered down momentarily after PCB code entry.
2. Even though PCB codes display as being changed, they are not entered into working memory until
the system DC power is cycled OFF and ON.
3, If PCB codes are not entered into working memory by cycling DC power, PCB options will not
function.
4.
Only
Program
03 requires the system power to be turned OFF and ON to store data into working
memory.
-19-