Toshiba STRATA DK24 Manual page 667

REMOTEADMlN&MAlNTPROCEDURES
SECTlON200-096-600
FEBRUARY1991
TABLERM-BE
MODE97
REMOTECALLINGSTATION MESSAGlNG(ADD/CHANGE)
TEP
ACTION
DISPLAY/PRINTOUT
1
Enter the Message Mode
>MODE MESG
At the >MODE prompt, enter m 0 lI[9
.
2 To Add a Message (or change a previously stored message)
m 97
Set the terminal keyboard to lower case (caps lock off) and
enter 110
NOTE:
Enter I'm" at anytime it is desired to start over in this procedure.
3
Enter 1 1 0(XxX = station number for which the message will m97 XXX
be set and stored).
4 Enter: 1 00 (p = page command and
170 = 2-digit message memory location: IO * 19 personal
m97 XXX p 00
messages and 60 w 99 = system messages).
NOTE:
To store system message change permanently, EKT XXX must be
station assigned to port 00.
5
To Add a Message
m97 XXX P 00
[Ml
Set the terminal keyboard to upper case and enter message
(alphanumeric, 32 characters max.). New message displays as
it is entered.
6 To Set the Message on the Electronic Telephone's LCD
Set the terminal keyboard to lower case and enter 1 m 1
m97 XXX P 00 WI P
m JL Zero
7 To Exit the Message Mode m0
At any time, enter 1 b 1 (lower case).
q
>MODE
NOTES:
1. To cancel a message set via Mode 95, use Mode 97 with any message number in
step 4, use this
procedure and skip step 5.
2. [M] represents the message entered.
3. With Release 2 software only, remote calling station messaging is not available from electronic
telephones, but it is available from ASCII terminals connected to the TTY port or via IMDU on the
PIOU or PIOUS.
-53-