Toshiba STRATA DK24 Manual page 498

FEATURE USE FEATURE USE
TIMED REMINDERS (continued)
TWO (TANDEM) CO LINE CONNECTION (continued)
On some systems, the connection must be supervised and
released as follows:
1) Press either
q
button.
l
Both CO LEDs flash at the In-use rate.
l
You will be connected to both CO lines.
2) If the parties have hung up, go back on-hook.
l
Both CO LEDs go off.
l
Connection is released.
3) If the parties are still talking, proceed to step 5 above.
NOTES:
1. CO lines may be accessed bypressing am line button
or by dialing access codes (line number, 70 1 - 736; line
group, 81 - 88; or with
Release
2 and higher, LCR
access "9" is allowed),. however, both CO lines must
appear (buttons) on the telephone to allow the station
to monitor the tandem connection.
2. If you receive a busy tone or no answer, return to the
original connection by pressing the original [9 line
button.
3. Depends on the public telephone company; some
provide auto disconnect and some do not.
TIMED REMINDERS
Allows five separate reminders to be set at each station. These
reminders will be an audible beeping at the times (hour and
minute) set by the station user. They can occur just once or
repeated on a daily basis.
TO ENTER A TIMED REMINDER
1) Dial~+~~~-~~~.Y ou h ave a choice of five different
reminders.
2) Enter the desired time (24-hour clock format; i.e., HHMM).
3) Dial 1 if reminder will be repeated every day, or 0 if it is a
one-time reminder only.
4) Press 1 (or m button to record the time in memory.
l
A beeping tone will be heard for 30 seconds (or until
cancelled by going off-hook) when the hour and min-
ute occur.
TO CANCEL A TIMED REMINDER
NOTE:
Repeat for reminders 1 m b - 1 B 1.
TOLL RESTRICTION OVERRIDE/TRAVELING CLASS
Toll restriction at a station can be completely overridden, or, with
Release 3, the station's normal class can be changed to another
class (traveling class). Use the following procedure to completely
override or to change a station's toll restriction class.
TO OVERRIDE TOLL RESTRICTION AT A STATION FOR A
SINGLE CALL
1) Access a CO line as normal.
2) Press the m button and dial 0 0.
l
If there was dial tone, it will noti cease.
3) Dial the Toll Restriction Override Code (four digits).
l
You will hear dial tone.
4) Dial the desired telephone number.
TO ADD, DELETE, OR CHANGE TOLL RESTRICTION
OVERRIDE OR TRAVELING CLASS CODES FROM
STATIONS SELECTED IN SYSTEM PROGRAMMING.
1) Press m and dial the three-digit toll restriction override
change access code CI CII 0".
l
You will hear confirmation tone.
2) Dial the four-digit override code It Cl It It.
3) Press the 1 or m button to store code.
48 49