Toshiba STRATA DK24 Manual page 292

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 200-096-301
FEBRUARY1991
TABLEl-E
PROGRAM03
Press...
FLEXIBLEPCBSLOTASSIGNMENTS
Ster, m + LED keys
ft'
I,
Action description LCD
RESPONSE . . .
1. Use the programming LCD electronic or digital telephone
NO. 205
with programming template connected to port 05 - circuit 6.
JAN 20 SUN
06:43
2. WmE~P~
PROGRAM MODE
Enter programming mode.
3. moom
Access Program 03. After m key is pressed, system
PROGRAM = 03
DATA STORE
beeps to indicate program number may be entered.
4. m
Prepare system for a selection.
5. Dial a PCB slot number (00-14) using the dial.
The system defaults as follows:
55
Initialized data assigns slot 00 to be a non-optioned
PCTU without CRCU.
50
Initialized data assigns slot 01 to be a non-optioned
PEKU without door phone, DSS console or OCA.
55-0~
Initialized data assigns slots 02 N 14 to be empty.
6. ~~-~[
Dial the PCB code recorded on the record sheet.
Refer to the PCB code reference table on Program
03
System Record Sheet for a definition of the codes.
03 SELECT =
03 SELECT = (00 _ 14)
CARD = (91, 21 or 00)
03 SELECT = 00
CARD = 91
=SLOT NUMBER
03 SELECT = 01
CARD=21
=SLOT NUMBER
03 SELECT = 02
CARD = 00
-%T NUMBER
03
SELECT = (00 - 14)
CARD = (00 - 93)
7. m
Secure data in system programming.
03 SELECT = (00 +. 14)
DATA PROGRAMMED
8. m
03 SELECT =
Prepare system for another selection (go back to
step 5), or exit Program 03 (continue with step 9).
9. [jm
03 SELECT = ##
Secure Program 03 data in system memory.
DATA PROGRAMMED
0. m
PROGRAM =
Exit Program 03. Enter another program number (see
Table E), or exit programming mode (go to step 11).
System beeps to indicate it's exiting Program 03.
1. [[m
NO. 205
Exit programming mode.
JAN 20 SUN
06:58
2.
In order to secure Program 03 entries, POWER OFF
for 5 seconds, then POWER ON.
I
I-II