Instrument Panelwarning Light Check; Fuel Level Sender - Yamaha MM700A Manual

ELECTRICAL SYSTEM
5. Remove the right handlebar switch assembly.
6. Installation the reverse of the preceding steps.
Main Switch
The main switch (Figure 34) is mounted on the center
cover.
1. Remove the rear handlebar cover.
2. Remove the center cover.
3. Disconnect the main switch electrical connector and
remove the main switch.
Installation is the reverse of the preceding steps.
Carburetor Switch
Refer to Throttle Override System in this chapter.
Throttle Switch
Refer to Throttle Override System in this chapter.
INSTRUMENT PANEL
WARNING LIGHT CHECK
The instrument panel (Figure 35) is equipped with a
water temperature warning light and an oil level warning
light.
The water temperature light comes on when coolant
temperature reaches
on while riding, stop the engine and allow it to cool before
restarting.
The oil level light comes on when the oil level in the oil
tank is low. Do not ride the snowmobile until the oil tank
is filled.
Warning Light Check
The water temperature and oil level warning lights can
be checked for proper operation.
When the main switch is turned on, the warning lights
on the instrument panel (Figure 35) should turn on. After
a few seconds, the warning lights should turn off. Interpret
these results as follows:
1. If a warning light did not come on after the main switch
was turned on, check the warning light bulbs as described
in this chapter. If the bulb is good, check the oil level
gauge or thermoswitch as described in this chapter.
2. If the water temperature warning light stayed on and
the engine shows no sign of overheating, check the
thermoswitch as described in this chapter.
3. If the oil level warning light stayed on and the oil tank
is full, check the oil level sender as described in this chap-
ter.

FUEL LEVEL SENDER

All models are equipped with an electrical fuel gauge.
The fuel gauge is connected to a fuel level sender (A, Fig-
ure 36) located in the fuel tank,
159