Yamaha MM700A Manual page 223

CHAINCASE, JACKSHAFT AND FRONT AXLE
and replace if necessary. Reverse to assemble the
tensioner.
Installation
Refer to Figure 1.
1. Install the spacers onto the jackshaft and front axle
(Figure 6).
2. Install the chain and sprockets. The necked side of the
driven sprocket (Figure 7) must contact the spacer on the
front axle.
3. Install the drive sprocket nut (A, Figure 5) and washer.
4. Apply Loctite 242 (blue) to the driven sprocket bolt
Figure 51, then install the bolt and washer.
5. Have an assistant apply the hydraulic brake. Tighten
the drive sprocket nut (A, Figure 5) to 60 N*m (43 fi.-lb.).
Tighten the driven socket bolt (B) to 48 N-m (35 ft.-lb.).
6. Install the chain tensioner (Figure 4).
7. Install the gasket and chaincase cover (Figure 3) onto
the chaincase. Make sure the rubber gasket properly fits
on the chaincase.
Three.
217