Check The Coolant Temperature Indicator Light - Yamaha 2012 Grizzly 300 Service Manual

CHECK THE COOLANT TEMPERATURE INDICATOR LIGHT

a
1
CHANGING THE COOLANT/
12.Fill:
• coolant reservoir
(with the recommended coolant to the
maximum level mark
13.Install:
• coolant reservoir cap
14.Start the engine, warm it up for ten minutes,
and then rev the engine five times.
15.Pour the recommended coolant into the radi-
ator until it is full.
16.Stop the engine and allow it to cool. If the
coolant level has dropped after the engine
has cooled add sufficient coolant until it re-
aches the top of the radiator, and then install
the radiator cap.
17.Start the engine, and then check for coolant
leakage.
Cracks/wear/damage → Replace.
18.Inspect:
• coolant level
Refer to "CHECKING THE COOLANT
LEVEL".
TIP
Before inspecting the coolant level, wait a few
minutes until the coolant has settled.
19.Install:
• front panel
• front carrier
Refer to "FRONT CARRIER, FRONT BUMPER
AND FRONT FENDER".
CHECK THE COOLANT TEMPERATURE
INDICATOR LIGHT
1.
Check:
• coolant indicator light
3-28
CHK
ADJ
)
a
1