Primary Sheave Service - Yamaha MM700A Manual

I
gauge against the sheaves (Figure 21). The gauge should
contact each sheave in at least two places at the same time.
If it does not, perform the following:
a. Loosen the front and rear engine mounting bolts
(Figure 19 and Figure 20). See Chapter Four.
specified in Table 3.
sheave distance. Refer to Chapter Four for en-
the
gine mount torque specifications.
d. Recheck sheave center-to-center distance and ad-
just if necessary.
e. After adjusting the sheave offset, perform the Sec-
Sheave Free
ondary
ter.
5. Reinstall the drive belt as described in this chapter.

PRIMARY SHEAVE SERVICE

The primary sheave (Figure 22) is mounted on the left
end of the crankshaft. Refer to Figure 5 when performing
the procedures in this section.
Play as described in this chap-
CHAPTER TEN
Primary sheave