Yamaha MM700A Manual page 134

128
CARBURETOR OPERATION
Air
5. Disconnect the connector leads to the throttle override
switch (Figure 10).
6. Loosen the jam nut (Figure 11) on the starter cable,
then unscrew and disconnect the starter cable.
7. Disconnect the throttle cable (Figure 12).
8. Label then disconnect the hoses from the carburetor.
Plug the hoses to prevent fuel leakage and contamination.
fur clarity.
9. Place a suitable container under each carburetor, then
remove the fuel drain screw (Figure 13) and drain the fuel
from each carburetor.
secure the carburetors to the intake tubes.
Be prepared to catch any residual coolant
that may dr@fiom the cat,buretors,
12. Reverse the removal steps to install the carburetor as-
sembly while noting the following.
a. Adjust the throttle cable as described in Chapter
Three.
b. Adjust the starter cable as described in Chapter
Three.
described in Chapter Three.
prevent a fuel leak.
leaking.
e. Make sure the intake tubes are properly positioned
and the hose clamps are tightened securely to pre-
vent an air leak.
1. Remove the carburetor assembly from the engine as
previously described.
Be prepared to catch arty residaal coolant
2. Remove the heater hoses (Figure 151 between the ear-
buretors.
CHAPTER FIVE