Yamaha MM700A Manual page 237

CHAINCASE, JACKSHAFT AND FROKT AXLE
3. Make sure the lugs engage the track correctly.
a. Slide the bearing onto the end of the front axle (Fig-
ure 38) so the lock collar is toward the inside of the
snowmobile.
Links
TRACK ALIGNMENT
Rear axle
Table 1 DRIVE CHAIN SPEClFiCATlONS
68
70
Front axle
Install the speedometer cable housing, making sure
the speedometer drive pin {Figure 47) properly en-
gages the holes in the front axle and speedometer
gear.
Install the retaining nuts and tighten securely.
Apply Loetite 242 (blue) to the bearing lock collar
setscrews. Install the setscrews (Figure 37) and
tighten to 8 N-m (71 in.-lb.).
Install the rear suspension as described in Chapter
Fourteen.
6. Install the collar (Figure 29) onto the front axle and
push the collar against the shafi shoulder.
7. Install the chain and sprockets as described in this
chapter.
8. Install the secondary sheave and drive belt as de-
scribed in Chapter Ten.
23 1