Parameter Indexing - Siemens MAG 1100 Operating Instructions Manual

Parameter Indexing

Parameters are indexed when they apply to more than one input or output. The index
value defines the input/output for that parameter. Indexed parameters contain a value for
each index, even if that index is not used.
MultiRanger Display
The index number and the index values are displayed above the parameter indicator on
the LCD.
Notes
• Transducers are always indexed when the dual point option is enabled.
• An indexed transducer is commonly referred to as a Point (short for
'Measurement Point'). Point Number refers to indexed transducers.
• To set all indexed values for a parameter to the same value, use index 0.
• MR 200 only: Transducer parameters are indexed only if Operation (P001) is set
to Difference (value=4) or Average (value=5) on a single point MultiRanger.
Accessing a Parameter Index
1. Press DISPLAY
2. Enter the new parameter number.
3. Press DISPLAY
4. Press the number of the required index. Or press ARROW keys
through the available values.
: For optimum performance, set values accurately for indexed parameters.
Note
Ensure that the correct index value is being changed for each parameter value.
7ML19981FB05 MultiRanger 100/200 – INSTRUCTION MANUAL
Index Number
1 2 3
once to clear current parameter field.
twice.
Index Value
4 5 6
to scroll
Page 35