Parameter Reset; Display Readout - Siemens MAG 1100 Operating Instructions Manual

Default Values
Parameter default values are indicated with an * in the parameter tables.
P000 Lock
Primary Index
Value
The asterix identifies 1954 as the default value.

Parameter Reset

Returning a parameter to factory default.
1. Display the appropriate parameter number.
2. Display the appropriate index value (if required).
3. Press CLEAR
4. Press ENTER
Master Reset (P999)
Returns all parameters to original values.
Use Conditions:
• before initial system installation
• following a software upgrade
If complete reprogramming is required, use Dolphin Plus to store and retrieve parameters.
When the dual point option is enabled, P999 is indexed by transducer. Use index 00 to
reset the entire MultiRanger.

Display Readout

The following readouts are shown when the MultiRanger cannot display a number.
Display
7ML19981FB05 MultiRanger 100/200 – INSTRUCTION MANUAL
Global
1954 * OFF: programming permitted
-1 Simulation Controls (relays energize based on
simulated level)
other ON: Lock activated and programming not permitted
.
.
Definition
Parameter has not been set
All values not same when viewing index 0
Value too large for four-digit display
Page 33