Removing The Disk Drive Tray - IBM PS703 Service Manual

1. Follow any special handling and installation instructions that come with the battery.
2. Tilt the battery so that you can insert it into the socket. Make sure that the side with the positive (+)
symbol is facing the correct direction.
3. Press the battery away from the DIMMs until fully inserted into the battery holder.
4. Install the battery cover.
5. Install and close the blade server cover. See "Installing and closing the blade server cover" on page
235.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade server cover before installing the blade server.
6. Install the blade server into the BladeCenter unit. See "Installing the blade server in a BladeCenter
unit" on page 232.
7. Turn on the blade server and reset the system date and time through the operating system that you
installed. For additional information, see your operating-system documentation.
8. Make sure that the boot list is correct using the management module Web interface. See the
management module documentation for more information) or the SMS Utility. See "Using the SMS
utility" on page 269 for more information.

Removing the disk drive tray

You can remove the disk drive tray.
Figure 44. Removing the disk drive tray
To remove the disk drive tray, complete the following steps:
260
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)