Table of Contents
Advertisement
Removing the hard disk drive tray
Each hard disk drive has a tray that you can remove when removing the hard disk
drive.
Figure 26. Removing a hard disk drive tray
Perform the following procedure to remove a hard disk drive tray.
1. Read "Safety" on page v and the "Installation guidelines" on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
5. Remove the hard disk drive if one is installed. See "Removing a SAS hard disk
6. Remove the four screws that secure the drive tray to the system board and
270
JS12 Type 7998: Problem Determination and Service Guide
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 241.
side up.
cover" on page 244.
drive" on page 248.
remove the drive tray.
Save the screws that secure the tray to the system board. Store the screws in a
safe place.
Hard disk drive tray
Advertisement
Table of Contents
