IBM PS703 Service Manual page 84

Table 18. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
Error code
BA01D054
BA01D055
BA01D056
BA01D0FF
BA030011
72
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
Description
DHCP::discover: DHCP nak received
DHCP::discover: DHCP decline
DHCP::discover: unknown DHCP
message
Closing the DHCP node failed.
RTAS attempt to allocate memory failed
Action
DHCP discovery did receive a DHCP offer
from a server that meets the client
requirements, but the server sent a DHCP not
acknowledged (DHCP nak) to the client DHCP
request.
Another client might be using the address that
was served.
This situation can occur when there are
multiple DHCP servers on the same network,
and server A does not know the subnet
configuration of server B, and vice-versa.
This situation can also occur when the pool of
addresses is not truly divided.
Set the DHCP server configuration file to
"authoritative".
Verify that the DHCP server is functioning
properly.
DHCP discovery did receive a DHCP offer
from one or more servers that meet the client
requirements. However, the client performed
an ARP test on the address and found that
another client was using the address.
The client sent a DHCP decline to the server,
but the client did not receive an additional
DHCP offer from a server. The client still does
not have a valid address.
Verify that the DHCP server is functioning
properly.
DHCP discovery received an unknown DHCP
message type. Verify that the DHCP server is
functioning properly.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.