IBM PS703 Service Manual page 94

Table 18. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
Error code
BA130014
BA130015
BA131010
BA140001
82
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
Description
USB CD-ROM in the media tray: the
media in the USB CD-ROM drive has
been changed.
USB CD-ROM in the media tray:
ATA/ATAPI packet command execution
failed.
The USB keyboard has been removed.
The SCSD read/write optical test unit
ready failed; hardware error.
Action
1. Retry the operation.
2. Reboot the blade server.
3. Troubleshoot the media tray and CD-ROM
drive.
4. Replace the USB CD or DVD drive.
5. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
1. Remove the CD or DVD in the drive and
replace it with a known-good disk.
2. If the problem persists:
a. Retry the operation.
b. Reboot the blade server.
c. Troubleshoot the media tray and
CD-ROM drive.
d. Replace the USB CD or DVD drive.
e. If the problem persists:
1) Go to "Checkout procedure" on
page 176.
2) Replace the system-board, as
described in "Replacing the FRU
system-board and chassis assembly"
on page 264.
1. Reseat the keyboard cable in the
management module USB port.
2. Check for server firmware updates; then,
install the updates if available.
1. Troubleshoot the SCSD devices.
2. Verify that the SCSD cables and devices are
properly plugged. Correct any problems
that are found.
3. Replace the SCSD cables and devices.
4. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.