IBM PS703 Service Manual page 99

Table 18. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
Error code
BA180012
BA180014
BA180020
BA180099
BA180100
BA180101
BA190001
Description
PCI device runtime error, bridge in
freeze state
MSI software error
No response was received from a slot
during PCI probing.
PCI probe error; bridge in freeze state,
slot in reset state
The FDDI adapter Fcode driver is not
supported on this server.
Stack underflow from fibre-channel
adapter
Firmware function to get/set
time-of-day reported an error
Action
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
1. Reseat the PCI adapter card.
2. Check for adapter firmware updates; then,
install the updates if available.
3. Check for server firmware updates; then,
install the updates if available.
4. Replace the PCI adapter card.
5. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
IBM may produce a compatible driver in the
future, but does not guarantee one.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
Chapter 2. Diagnostics
87