IBM PS703 Service Manual page 211

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Isolation
Symptom
Procedure Code
FSPSP17 A system
uncorrectable error
has occurred.
FSPSP18 A problem has been
detected in the
platform licensed
internal code (LIC).
A failing item has
FSPSP20
been detected by a
hardware procedure.
FSPSP22 The system has
detected that a
processor chip is
missing from the
system configuration
because JTAG lines
are not working.
FSPSP23 The system needs to
perform a service
processor dump.
FSPSP24 The system is
running in a
degraded mode.
Array bit steering
might be able to
correct this problem
without replacing
hardware.
An attention line has
FSPSP27
been detected as
having a problem.
FSPSP28 The resource ID
(RID) of the CRU
could not be found
in the Vital Product
Data (VPD) table.
Action
v Look for other serviceable events.
v Use the SRCs that those events call out to determine and fix any
problems.
1. Verify that the operating system is running. If it is running, perform
an in-band firmware update, as described in "Updating the firmware"
on page 267.
2. If the problem persists, replace the system board and chassis assembly,
as described in "Replacing the FRU system-board and chassis
assembly" on page 264.
Call IBM Support.
Replace the system board and chassis assembly, as described in
"Replacing the FRU system-board and chassis assembly" on page 264.
1. Save the service processor dump to storage by using the partition
dump pin control on the control panel.
2. Once the dump is complete, attempt to re-IPL the system.
3. Call IBM Support.
1. Power off the blade server, as described in "Turning off the blade
server" on page 8.
2. Remove the blade server from the BladeCenter unit and reinsert the
blade server into the BladeCenter unit.
3. Power on the blade server, as described in "Turning on the blade
server" on page 7.
4. If the problem persists, replace the CRU that is called out after this
procedure.
Replace the CRU that is called out before this FSPSP27 call. If the CRU
does not correct the problem, call IBM Support.
1. Find another callout that reads "FSPxxxx" where xxxx is a 4-digit hex
number that represents the resource ID. Record the resource ID and
the model of the system.
2. Call IBM Support to find out what CRU the resource ID represents.
3. Replace the CRU that the resource ID represents.
199
Chapter 2. Diagnostics