Table of Contents
Advertisement
Figure 21. Installing the cover for a PS704 blade server
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always replace
the blade server cover before installing the blade server.
Perform the following procedure to replace and close the blade server cover.
1. Read the Safety topic and the "Installation guidelines" on page 229.
2. Lower the cover so that the slots at the rear slide down onto the pins ( 1 in Figure 20 on page 235)
at the rear of the blade server. Before you close the cover, verify that all components are installed and
seated correctly and that you have not left loose tools or parts inside the blade server.
3. Pivot the cover to the closed position until the releases ( 2 ) click into place in the cover.
4. Install the blade server into the BladeCenter unit. See "Installing the blade server in a BladeCenter
unit" on page 232.
236
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
Advertisement
Table of Contents
