IBM PS703 Service Manual page 169

Table 27. 101-711 through FFC-725 SRNs (continued)
SRN FFC
268B-640 268B
26B4-102 26B4
26B4-104 26B4
26B4-105 26B4
26B4-106 26B4
26B4-108 26B4
26B4-110 26B4
26B4-112 26B4
26B4-114 26B4
26B4-116 26B4
26BD
26B4-117 26B4
26B4-118 26B4
26BD
252B
26B4-120 26B4
26BD
26B4-122 26B4
26BD
26B4-124 26B4
26BD
26B4-126 26B4
26BD
252B
26B4-128 26BD
252B
26B4
Software
26B4-129 26BD
252B
26B4
Software
Description and Action
Error log analysis indicates a path error.
1. Check the BladeCenter management-module event log. If an error was recorded by
the system, see "POST progress codes (checkpoints)" on page 97.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in Replacing the Tier 2
system-board and chassis assembly.
An unrecoverable media error occurred.
The motor failed to restart.
The drive did not become ready.
The electronics card test failed.
The bus test failed.
The media format is corrupted.
The diagnostic test failed.
An unrecoverable hardware error.
A protocol error.
Check the levels of the device, adapter, diagnostic software, and application software to
be sure they are all compatible. If you do not find a problem, call your support person.
A write-protect error occurred.
A SCSI command time-out occurred.
A SCSI busy or command error.
A SCSI reservation conflict error.
A SCSI check condition error occurred.
A software error was caused by a hardware failure.
The error log analysis indicates a hardware failure.
Error log analysis indicates a SCSI bus problem.
157
Chapter 2. Diagnostics