IBM PS703 Service Manual page 208

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Isolation
Symptom
Procedure Code
FSPSP03 A system operator or
user error has
occurred.
FSPSP04 A problem has been
detected in the
service processor
firmware.
FSPSP05 The service processor
has detected a
problem in the
platform firmware.
FSPSP06 The service processor
reported a suspected
intermittent problem.
FSPSP07 The time of day has
been reset to the
default value.
196
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
Action
Refer to the documentation for the function you were attempting to
perform.
1. Verify that the operating system is running. If it is running, perform
an in-band firmware update, as described in "Updating the firmware"
on page 267.
2. If the problem persists, replace the system board and chassis assembly,
as described in "Replacing the FRU system-board and chassis
assembly" on page 264.
1. Verify that the operating system is running. If it is running, perform
an in-band firmware update, as described in "Updating the firmware"
on page 267.
2. If the problem persists, replace the system board and chassis assembly,
as described in "Replacing the FRU system-board and chassis
assembly" on page 264.
Contact IBM Support.
1. Use the chdate command to set the Virtual I/O Server date and time,
using one of the following syntaxes:
chdate [-year YYyy]
[-month mm]
[-day dd]
[-hour HH]
[-minute MM]
[-timezone TZ]
chdate mmddHHMM[YYyy|yy]
[-timezone TZ]
2. If the problem persists, replace the battery, as described in "Removing
the battery" on page 258 and "Installing the battery" on page 258.