Table of Contents
Advertisement
Table 39. Memory module combinations for the PS704 blade server (continued)
DIMM
count
10
X
X
X
X
X
X
12
14
X
X
X
X
X
X
16
Figure 37. DIMM connectors for the PS704
See "Supported DIMMs" on page 4 for additional information about the type of memory that is
compatible with the blade server.
To install a DIMM, complete the following steps:
1. Read the Safety topic and the "Installation guidelines" on page 229.
2. Read the documentation that comes with the DIMMs.
3. Shut down the operating system, turn off the blade server, and remove the blade server from the
BladeCenter unit. See "Removing the blade server from a BladeCenter unit" on page 231.
4. Carefully lay the blade server on a flat, static-protective surface, with the cover side up.
5. Open and remove the blade server cover. See "Removing the blade server cover" on page 233.
Note: If you are servicing the base unit of a PS704 blade server, you must first remove the expansion
unit. For more information, see "Removing the expansion unit for a PS704 blade server" on page
237.
252
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
PS704 base blade unit (P1) DIMM slots and expansion unit (P2) DIMM slots
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Advertisement
Table of Contents
