Removing A Hard Disk Drive - IBM System x3610 Problem Determination And Service Manual

Low-profile
PCI 33 MHz
adapter
1. Install the adapter in the expansion slot.
2. Install the screw that holds the adapter in the expansion slot.
3. Connect any required cables to the adapter.
4. Perform any configuration tasks that are required for the adapter.
5. Install the cover (see "Installing the cover" on page 46).
6. Slide the server into the rack and tighten the rack release thumbscrews.
7. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing a hard disk drive

To remove a hard disk drive from a hot-swap bay, complete the following steps.
Hard disk
drive filler
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Move the handle on the drive to the open position (perpendicular to the drive).
3. Pull the hot-swap drive assembly from the bay.
50
IBM System x3610 Type 7942: Problem Determination and Service Guide
Low-profile
PCI Express x8
adapter
Attention:
v When you route cables, do not block any connectors or the ventilated space
around any of the fans.
v Make sure that cables are not routed on top of components.
v Make sure that cables are not pinched by the server components.
peripheral devices and the server.
on page 43.
Hard disk drive