IBM PS703 Service Manual page 171

Table 27. 101-711 through FFC-725 SRNs (continued)
SRN FFC
26D2-124 26D2
26D2-126 26D2
252B
26D2-128 252B
26D2
Software
26D2-129 252B
26D2
Software
26D2-130 26D2
26D2-132 26D2
26D2-134 252B
Software
26D2-135 26D2
252B
Software
26D2-136 26D2
26D2-137 26D2
252B
26D2-138 26D2
26D2-140 199
252B
26D2
26D2-640
2D02-xxx 2631
2E00-201 2E00 221
Description and Action
A SCSI check condition error occurred.
A software error was caused by a hardware failure.
The error log analysis indicates a hardware failure.
Error log analysis indicates a SCSI bus problem.
Error log analysis indicates a problem reported by the disk drive's self-monitoring
function.
A disk drive hardware error occurred.
The adapter failed to configure.
The device failed to configure.
The certify operation failed.
Unit attention condition has occurred on the Send Diagnostic command.
Error log analysis indicates that the disk drive is operating at a higher than
recommended temperature.
Check to be sure none of the air passages in the system covers are blocked, that no
other system environmental warnings are occurring.
Error log analysis indicates poor signal quality.
Error log analysis indicates a path error.
Generic reference for USB controller/adapter - system-board and chassis assembly. Go
to "Performing the checkout procedure" on page 177.
Configuration error.
1. Check the BladeCenter management-module event log. If an error was recorded by
the system, see "POST progress codes (checkpoints)" on page 97.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board
159
Chapter 2. Diagnostics