Omron LD-60 User Manual page 43

b. Lift the wheel slightly to relieve pressure on the pin, then remove the pin by
c. Reinstall the two side skins.
12. Install the battery in the platform.
The platform brakes cannot be released until the battery is installed. Refer to Installing
the Battery on page 44.
11970-000 Rev M
pulling the attached ring. See the following figures.
Save these pins for later service of the drive assemblies.
Figure 3-12. Wheel Pin Hole (Yellow Arrow)
LD-60/90 Platform User's Manual
Figure 3-13. Wheel Pin
Chapter 3: Setup
43