Omron LD-60 User Manual page 156

8.7 Replacing Non-Periodic Parts
Figure 8-22. Right Side Skin, Showing Even Gaps at Edges
NOTE: The gaps between the side skins and the bumper will be smaller than
the other gaps, and will not be even.
Access Panel
1. Slide the panel to the right, so its tab goes under the left side skin.
A lanyard attaches the panel to the skin to prevent getting lost.
2. Press the left (front) side of the panel in, and the latch will hold it.
This is a toggle latch - pressing it once engages it, pressing it a second time releases it.
Battery Door Skin
1. Slide the skin up, so its top tab fits under the rear skin.
!
2. Hold the skin near the center and, with both hands, tilt the bottom of the skin down,
towards the platform chassis.
156
CAUTION: PINCH RISK
This skin is the most likely to pinch you if you are not careful, par-
ticularly at its bottom edge. Hold the skin at the bottom, in the center,
with two hands.
LD-60/90 Platform User's Manual 11970-000 Rev M