Omron LD-60 User Manual page 155

Rear Skin
Because this skin houses the rear sonar units, you must reconnect them once the metal brace
across the bottom is in the clip just below the battery access hole.
1. Slide the metal brace into the chassis clip.
Watch the two magnets on the bottom of the skin and align them with the magnets on
the chassis. This is your best guide for getting this skin in its proper place.
These are inboard of the clip holding the brace, so you will have to look on each side of
the skin to check their alignment.
2. After aligning the magnets at the bottom, tilt the skin up to within a few centimeters of
the chassis.
3. Pull the sonar connectors out of the chassis (if not already out).
4. Screw the four sonar connectors to their corresponding sonar leads.
Ensure that the labels for the connectors and leads match.
5. Tuck the connectors into the four holes in the chassis, until just an centimeter of sonar
lead is sticking out.
6. Tilt the top of the skin up to meet the chassis.
Side Skins
1. Move the skin to within a few centimeters of the chassis, and plug in the light disc con-
nector.
Connect the light disc to the fitting on the inside of the side skin.
2. Place the top edge of the skin on the chassis, so the magnets hold it there.
Make sure the gaps on each side of the skin are the same width.
3. Tilt the bottom edge of the skin down.
4. Check each side of the skin to ensure that the skin edges on each side of the gap stick
out the same amount away from the chassis.
This is most likely to be uneven near the top of the skin.
5. If either edge sticks out more than the neighboring skin, pull the neighboring skin away
from the side skin slightly, and release.
This should allow the side skin to snap into place, so both sides of the gap stick out the
same amount.
Repeat for the other side skin.
11970-000 Rev M LD-60/90 Platform User's Manual
Chapter 8: Maintenance
155