Docking The Next Peripheral Device; Mounting The Tray Unit - Ricoh MP C6502SP Field Service Manual

2. Installation
20. Close the front door.

Docking the Next Peripheral Device

The next peripheral device to the left of the cover interposer tray must be installed before you can mount
the tray unit on top of the transport unit of the cover interposer tray.
• The tray unit of the cover interposer tray is supported by the top of the next peripheral device in line
to the left, as well as the transport unit of the cover interposer.
• The next peripheral device to the left of the cover interposer must be set up and docked to the cover
interposer before the transport unit of the cover interposer can be mounted.
Connect the next peripheral unit now.
• Finisher SR4110 (
• Never attempt to mount the cover interposer tray unit until the next device in line has been docked
to the transport unit (base) of the cover interposer tray.
• To prevent bending the frame of the tray unit and damaging its alignment, always remove the tray
unit from the cover interposer tray transport unit: (1) Before disconnecting either the cover
interposer tray or the next peripheral device to the left, or (2) Before doing any maintenance on
either the cover interposer tray or the next peripheral device to the left.

Mounting the Tray Unit

1. Remove the rear cover [A] ( x2).
2. Confirm that the connectors [B] are free.
3. Place the tray unit [C] on top of the cover interposer transport unit.
324
page 185 "Finisher SR4110 (D707)")