Ricoh MP C6502SP Field Service Manual page 339

2. The slotted screw holes in the rail for attaching the rail to the LCT have a tolerance for the height
(-/+ 2 mm). If you can install the rail within -/+ 2 mm in height, you do not need to do the
following steps.
3. If you cannot install the rail within -/+ 2 mm in height, change the rubber foot position to adjust the
height of the rail.
• If the screw holes of the main machine are above the slotted holes of the rail, change the
rubber foot position as shown below.
• If the screw holes of the main machine are below the slotted holes of the rail, change the
rubber foot position as shown below.
LCIT RT4020 (D709)
337