Attaching the Wide Mylar to the Lower entrance guide
1. Peel off the sheet from the double stick tape [C] on the Wide Mylar.
2. Attach the Wide Mylar to the Lower entrance guide by aligning the edge [D] of the Mylar
with the edge (1) of the guide plate, and edge [E] of the double stick tape with the edge (2) of
the guide plate.
• Same as when connecting buffer pass unit to the mainframe.
3. Confirm the Wide Mylar is attached correctly to the Lower entrance guide as shown in the
photo below.
Buffer Pass Unit Type 5020 (D751) (D137/D138 Only)
273