Ricoh MP C6502SP Field Service Manual page 130

2. Installation
1. Place the four shoes [A] below the bolts [B] under each corner of the machine.
2. Turn the nuts [B] to lower the bolt until the bolts reaches to the leveling shoes [A].
Example below: Front side
• Use a wrench to raise or lower the nuts.
3. Open the ADF, and then place a level [A] on the exposure glass.
4. Adjust the machine level until the machine is less than 5mm from level (measure from left-to-right).
• When the right side of the machine is lower: Lower the nuts of the right side of the machine
(front and rear) to lift the right side of the machine.
128